Audiovox MM56A - Manual (Page 6)

128-6544
6 of 12
9) Using your fingers, tear the
foam out of the headrest leav-
ing a recess where the shell will
be inserted.
NOTE: At this point you will need
to install the harness up through the
area into the recess. It may be help-
ful to follow one of the posts and tie
wrap it to the post for restraint.
6) Using the utility knife, cut the
headrest material along the
“X” lines. Do not cut the mate-
rial along the other lines at this
time.
7) This will leave you with an “X”
cut as shown.
8) Pull the flaps up and cut the
foam beneath the material to
the proper depth. Cut all four
sides of the foam.
6