Tabs horizontal, Tabs clear horizontal, Tabs horizontal -15 – Agilent Technologies N-Series User Manual
Page 39: Tabs clear horizontal -15
User’s Manual
Page
4-18
Tabs Horizontal
▲
▲
▲
▲
▲
COMMAND:
COMMAND:
COMMAND:
COMMAND:
COMMAND:
s
t#
t#
t#
t#
t#
1
1
1
1
1
,#
,#
,#
,#
,#
2
2
2
2
2
,...#
,...#
,...#
,...#
,...#
64
64
64
64
64
d
▲
▲
▲
▲
▲
RANGE:
RANGE:
RANGE:
RANGE:
RANGE:
See
See
See
See
See
Margins
Margins
Margins
Margins
Margins command
command
command
command
command
This command sets the horizontal tabs, where #
n
is the value of the tab
expressed in 1/60" or 1/300" units. As many as 64 horizontal tab values
may be entered.
For example, using a 1/60" unit of measure, to set tab stops at 0.75", 3.0"
and 4.5", enter:
s
t45,180,270
d
The following list outlines the rules for setting horizontal tab stops:
▲
Default tab stops begin at 1.1" from the left side of
the page and are at every 0.44" thereafter.
▲
Tabs may be entered in any order.
▲
If more than 64 tab values are entered, the excess
tabs will be deleted, starting with the right most tab
value.
▲
The maximum tab position is 815 (13.58").
▲
Tabs are not effective beyond margins.
▲
If the page orientation is changed, the tab settings
must also be changed.
▲
Tab settings remain valid until the “Reset” or “Clear
Horizontal Tabs” commands are sent.
Tabs Clear Horizontal
▲
COMMAND:
COMMAND:
COMMAND:
COMMAND:
COMMAND:
s
d
d
d
d
d
▲
RANGE:
RANGE:
RANGE:
RANGE:
RANGE:
N/A
N/A
N/A
N/A
N/A
This command clears all horizontal tab settings.