Nilfisk-ALTO R 680 P - Manual (Page 80)

ENGLISH USER MANUAL
14 FLOORTEC R 680 P 1463514000(1)2008-05 A
USE
10 11
12
54
18
72
73
76
74
75
77
78
80
81
82
79
31
69
66
71
P100212
WARNING!
On some points of the machine there are some adhesive plates indicating:
DANGER –
WARNING –
CAUTION –
CONSULTATION –
While reading this Manual, the operator must pay careful attention to the symbols shown on the plates.
Do not cover these plates for any reason and immediately replace them if they are damaged.
BEFORE STARTING THE MACHINE
If it is necessary, unscrew the plug (31) and refuel the machine. 1.
WARNING!
Leave at least a space of 4 cm in the fi ller to allow the fuel to expand.
Make sure that there are no open doors/hoods and that the machine is in normal operating conditions. 2.
If the machine has not been used after being transported, check that all the blocks used for the transportation have been 3.
removed.
STARTING AND STOPPING THE MACHINE
Starting the machine
Sit on the driver’s seat (54), then adjust the seat in order to reach a comfortable position by using the lever (79). 1.
Unlock the knob (73) by pulling it, then tilt the steering wheel (72) in order to reach a comfortable position. After the adjustment, 2.
release the knob (73) and slightly move the steering wheel to lock it.
Engage the parking brake with the pedal (82) and the lever (75).
3.
Lift the main and side brooms with the levers (80), (77), (78). 4.
Pull the engine choke lever (74). 5.
NOTE
Do not use the choke lever if the engine is hot and if the air temperature is suffi ciently high.
Start the engine with the ignition key (69). When the engine starts, release the ignition key immediately. 6.
WARNING!
When starting the engine with the ignition key (69) do not press the drive pedal (76).