Ultra Start 1250 - Manual (Page 3)

Owners Guide
3 sec.
While
running
REMOTE STARTER FEATURES
1st
2nd-6 sec
Diagnostics
Remote Stop
Idle Mode
1.Press and release the button.
2.The Park lights will flash and the horn(optional) will honk one time.
3.When the vehicle has started, the system will flash the park lights four times then remain “On” while
the vehicle is running.
4. The vehicle will continue to run for the programmed runtime. (normally 15 minutes).
1.Press and release the button while the vehicle is remote started.
2.The system will respond with one park light flash and one horn honk (optional) to
confirm Extended Runtime. The system will reset the run time, (normally 15 minutes).
Remote Start
Extended Run Time
1.Press and hold the button for three seconds. The remote starter will shut down.
2.The park lights will flash two times and the horn(optional) will honk two times.
Note: Pressing the brake pedal or opening hood will also stop the vehicle.
1.While the vehicle is running with key, press the button.
2.The park lights will turn on and the horn(optional) will honk once.
3.Turn the ignition key “Off” and the vehicle will continue to run.
4. Exit the vehicle and leave it running safely without the keys in the ignition. Always lock the doors if the
vehicle is left running.
Timer Mode. (Starts the vehicle in at a pre-set start interval)
1.Press and release the # button, then press and hold the button for six seconds. The parking lights
turn “On” to confirm entering Timer Mode.
2. While the park lights are “On” the start cycle can be selected.
1 hour cycle Press LOCK button 1 Park Light Flash
2 hour cycle Press UNLOCK button 2 Park Light Flashes
3 hour cycle Press button 3 Park Light Flashes
4 hour cycle Press button 4 Park Light Flashes
3. The system will start the vehicle at the selected start cycle. The vehicle will run for it’s runtime then
shut off. The system will repeat this for a maximum 24 hour period.
TO CANCEL TIMER MODE
1.
Press and release the # button, then press and hold the button for four seconds.
2. The System will respond with two flashes and two horn honks (optional).
3. Starting the vehicle with the key or by remote will also disable Timer Mode.
#
PARK LIGHTS STATUS LED DIAGNOSTIC CODE
3 Flashes Series of 3 Flashes Door Opened “M” Models
3 Slow Flashes LED’s On Solid System Is In Service Mode
4 Slow Flashes Series of 4 Flashes Not in Reservation Mode “M” units
5 Flashes Series of 5 Flashes Brake Pedal Shutdown
5 Slow Flashes Series of 5 Flashes Ignition On During Start Attempt
6 Flashes Series of 6 Flashes Hood Pin Grounded
7 Flashes Series of 7 Flashes Tach Lock-Out
8 Flashes Series of 8 Flashes 3 Start Attempts with no start