Audiovox 50-0311x-015 Series User Manual
Page 3
3
I. PREPARATION OF VEHICLE INTERIOR
1. Remove and retain (3) three screws which secure
dome light in place. See Figure 1.
2. Disconnect wiring and lay light in a safe place.
3. Using O.E. console as a reference, carefully
measure and trim headliner as shown. Caution:
Before cutting headliner material, check for
wiring or other componentry above headliner.
Cut only where indicated. DO NOT OVERCUT
HEADLINER. Make sure that the 7 1/2" cut is
centered left to right in vehicle. See Figure 2.
4. If speaker upgrade kit was purchased, trim these (*)
locations. See Figure 2.
5. Construct a jumper harness that will connect the
vehicle’s dome light wires to the lights in video
system. Connect the white wire from video system
to the O.E. pink/blue wire. Connect the black wire
from video system to the chassis ground.
See Figure 3.
6. Using a test light, check function of lights.
7. Install O.E. dome light in original manner.
FIGURE 1
FIGURE 2
FIGURE 3