Sony KDL-40XBR7 - Manual (Page 7)

7
G
e
tting Started
3 Gently slide the TV unit onto the neck of the
Table-Top Stand and align the screw holes.
~
• Do not put stress on the LCD panel or the frame
around the screen.
• Be careful to not pinch your hands or the AC power
cord when you install the TV unit to the Table-Top
Stand.
4 Use the supplied screws to attach the TV unit
to the Table-Top Stand (refer to the “Attaching
the Table-Top Stand” flyer).
~
• For attaching the Table-Top Stand for KDL-70XBR7,
visit
www.sony.com/accessories
Or call 1-800-488-7669(for United States)
1-877-899-7669(for Canada)
All models are ready to be mounted on a wall.
• For product protection and safety reasons,
Sony strongly recommends that you use the
Wall-Mount Bracket model designed for your
TV and the wall-mounting of your TV should
be performed by a Sony dealer or licensed
contractor.
• Sufficient expertise is required in installing this
TV, especially to determine the strength of the
wall for withstanding the TV’s weight.
• Be sure to use the screws supplied with the Wall-
Mount Bracket when attaching the mounting
hooks to the TV set.
The supplied screws are designed so that they are
8 mm to 12 mm in length when measured from
the attaching surface of the mounting hook.
The diameter and length of the screws differ
depending on the Wall-Mount Bracket model.
Use of screws other than those supplied may
result in internal damage to the TV set or cause it
to fall, etc.
• Be sure to store the unused screws and Table-Top
Stand in a safe place until you are ready to attach
the Table-Top Stand. Keep the screws away from
small children.
For details on how to use the Wall-Mount Bracket
compatible to your model, visit
www.sony.com/accessories
Or call 1-800-488-7669 (for United States)
1-877-899-7669 (for Canada)
Make sure that your TV has adequate air
circulation. Allow enough space around the TV as
shown below. Avoid operating the TV at
temperatures below 41 °F (5 °C).
Preparation for Wall-Mount Bracket
If an electric
screwdriver is used, set
the torque to tighten at
approximately 1.5 N·m
{15 kgf·cm}.
KDL-40XBR7, KDL-46/55XBR8
When Installing the TV Against a Wall
or Enclosed Area
8-12 mm
Screw (supplied with the Wall-Mount
Bracket)
Mounting Hook
Rear of the TV set
(30 cm)
11 7 /
8 inches
(6 cm)
inches
4 inches
(10 cm)
4 inches
(10 cm)
2 3 /
8
Leave at least this much space around the set.
Installed with stand
inches 11 7 / 8
4 inches
(10 cm) 4 inches
(10 cm)
4 inches (10 cm)
(30 cm)
Installed on the wall
Leave at least
this much space
around the set.
(Continued)