Sony DSC-P30 - Manual (Page 70)

70
SETUP 2
Notes on [DATE/TIME]
• The date and time do not appear on the LCD screen during shooting. These appear during
playback.
• The date and time are not superimposed onto moving images and Clip Motion images.
Item Setting Description
LCD
BRIGHTNESS BRIGHT
x NORMAL
DARK
Selects the LCD brightness.
This has no effect on the recorded images.
LCD
BACKLIGHT BRIGHT
x NORMAL
Selects the brightness of the LCD backlight.
Lets you set the brightness of the LCD
backlight to [BRIGHT] or [NORMAL].
Selecting [BRIGHT] makes the screen
bright and easy to see when using the
camera outdoors or in other bright locations,
but also uses up the battery charge faster.
BEEP SHUTTER Turns on the shutter sound only. (The shutter
sound is heard when you press the shutter
button.)
x ON
Turns on the beep/shutter sound (when you
press the control button/shutter button).
OFF Turns off the beep/shutter sound.
VIDEO OUT NTSC Sets the video output signal to NTSC mode
(e.g., Japan, the USA) (page 74).
PAL Sets the video output signal to PAL mode
(e.g., Europe) (page 74).
USB CONNECT PTP Switches the USB mode (page 30).
x NORMAL
POWER SAVE
x ON
Set to ON to extend the battery life when
operating the camera with batteries.
OFF When POWER SAVE is set to ON, the time
from when you press the shutter button until
the image is recorded is longer than normal
(pages 11, 88).
The LCD screen turns off while the flash is
charging.
DEMO
x ON/STBY
Displayed only when you use the AC power
adaptor. [DEMO] is set to [STBY] at the
factory and the demonstration starts about
10 minutes after you have set the mode dial
to
or . To cancel the demonstration,
turn off the power. The demonstration will
not start if the MOVING IMAGE setting is
CLIP MOTION.
OFF