Sony HDR-TG5 - Manual (Page 20)

0
Table of C
on
ten
ts
U
seful R
ec
or
ding
Techniques
Inde
x
To remove the battery pack
Turn off your camcorder and open the battery/Memory Stick Duo cover.
Slide the BATT (battery) release lever (), then eject the battery pack ().
Be sure not to drop the battery pack.
To use a wall outlet (wall socket) as a power source
Make the same connections as “Step 1: Charging the battery pack.” Even if the battery pack is
attached, the battery pack is not discharged.
Charging the battery pack abroad
You can charge the battery pack in any countries/regions using the AC Adaptor supplied with
your camcorder within the AC 100 V - 240 V, 50 Hz/60 Hz range.
Do not use an electronic voltage transformer.
Notes on the battery pack
When you remove the battery pack or disconnect the AC Adaptor, close the LCD screen and make sure
that the (Movie) lamp/ (Photo) lamp (p. 22) are turned off.
The /CHG (charge) lamp flashes during charging under the following conditions:
The battery pack is not attached correctly.
The battery pack is damaged.
In the default setting, the power turns off automatically if you leave your camcorder without any
operation for about 5 minutes, to save battery power ([A.SHUT OFF], p. 96).
Notes on the AC Adaptor
Use the nearby wall outlet (wall socket) when using the AC Adaptor. Disconnect the AC Adaptor from
the wall outlet (wall socket) immediately if any malfunction occurs while using your camcorder.
Do not use the AC Adaptor placed in a narrow space, such as between a wall and furniture.
Do not short-circuit the DC plug of the AC Adaptor or battery terminal with any metallic objects. This










DC IN jack
Open the jack cover
DC plug
With the  mark on the bottom