Sony PEG-T415 - Manual (Page 22)

PictureGear Pocket
3.2
Advanced Functions of
PictureGear Pocket
3
Beam pictures to another CLIE Handheld
PictureGear Pocket enables you to send pictures to the PictureGear
Pocket application of another CLIE handheld using Infrared (IR)
communication.
Preparations
Turn on IR communication for both the sending and receiving CLIE
handhelds. Check whether the IR ports of the sending side and
receiving side are positioned properly so that communication is
possible between them. Place both CLIE handheld units so that
their IR ports are facing each other. The distance between them
should be 4 - 8 inches (10 - 20 cm). There should be no obstruction
between the units. Make sure that PictureGear Pocket is installed in
both of the receiving and sending devices. The optimal data transfer
distance may differ depending on the operational relation between
the CLIE handhelds. If transmission failes change the distance and
try the procedure again.
Start the PictureGear Pocket application of the sending side the
CLIE handheld.
Selecting a picture
Switch the PictureGear Pocket application of the sending side
handheld to the selection mode (Preview Mode or List Mode) and
then select a picture to be transferred.
See "Selecting a picture in Preview Mode" on page 2.2
or See "Selecting a picture in List Mode" on page 2.3.
Beam a picture
After switching the screen to Full Screen Mode, select [Menu] –
[Image] – [Beam] in the menu. PictureGear Pocket detects the
receiving side CLIE handheld and starts beaming the picture if
communications are possible.
Do not move the CLIE handheld units until the picture is transferred.
After beaming the picture, the sending side CLIE handheld returns to the state before
the sending operation. The receiving side CLIE handheld displays the received picture
in Full Screen Mode.
Even if the PictureGear
Pocket application of the
receiving side CLIE handheld
is not started when the
picture is received, the CLIE
handheld still receives the
picture. In this case, start
PictureGear Pocket after
receiving the picture. You can
display the received picture in
Full Screen Mode.
You can transfer only one
picture at one time. You
cannot transfer multiple
pictures.
DCF format picture stored in
Memory Stick media is not
transferable by IR
communication.
PictureGear Pocket Ver. 1.x
is not adaptable for a picture
in 16 bit color.
If a picture in 16 bit color
created by the PictureGear
Pocket Ver. 2.x is sent to a
CLIE handheld with the
PictureGear Pocket Ver. 1.x
by IR communication, a White
(blank) screen is displayed.
To return to the state before
the transfer by IR
communication, tap the
Stylus anywhere on the
screen.
Searching for receiving
side CLIE handheld
4
- 8
inche
s
Receiving
Side
Sending
Side