Antec CP-1000 - Manual (Page 4)

A
DVANCED
H
YBRID
C
ABLE
M
ANAGEMENT
The CP-1000 uses Advanced Hybrid Cable Management. Cables that are important or mandatory are permanently
connected to the PSU for the highest quality power delivery. There are modular jacks on the back of the PSU to
add additional cables as needed. Using only the cables you need will reduce clutter and improve airflow inside your
case. For the list of connected and optional cables, see Table 2.
M
ODULAR
C
ABLE
J
ACKS
There are two black jacks and two red jacks on the back of your CP-1000 PSU. These jacks are for the optional
cables that come with your power supply. The black connectors are used for Molex or SATA cables. Because of the
high power requirements of modern graphics cards, the red cables are set up to handle their needs. If you are not
using the red connectors for PCI-Express connectors, then you can use them for additional Molex or SATA cables as
needed.
T
ABLE
2
Cable Quantity Power Connectors Part Name Description
N/A Power supply direct cabling
24-pin (20 + 4) main connector
4 + 4-pin ATX12V, EPS
8-pin EPS12V
2 × 8-pin (6 + 2) PCI-E
3 × Molex + 1 × Floppy
3 × SATA
1
x 3
Molex connector w/cable
Includes three
Molex connectors
3
x 3 Serial ATA connector w/cable
Includes three Serial ATA connectors
2
x 1
PCI-Express connector w/cable
Includes one 6-pin
PCI-Express connector