Sony DCR-SR46BDL - Manual (Page 14)

1
the AC Adaptor from the DC IN jack.
Disconnect the AC Adaptor from the
DC IN jack holding both the DC plug
and the Handycam Station (DCR-SR65/
SR85) or your camcorder (DCR-SR45/
SR46).
Tips

For DCR-SR65/SR85:

Same as DCR-SR45/SR46, you can charge the
battery pack by connecting the AC Adaptor
to your camcorder.
For DCR-SR65/SR85:
To remove your camcorder from the
Handycam Station
Turn off the power, then remove the
camcorder from the Handycam Station
holding both your camcorder and the
Handycam Station.
To remove the battery pack
Turn the POWER switch to OFF (CHG).
Slide the BATT (battery) release lever and
remove the battery pack.

Notes

When you remove the battery pack or
disconnect the AC Adaptor, make sure that the
(Movie) lamp/ (Still) lamp (p. 17)/
ACCESS lamp (p. 25) is turned off.

When you store the battery pack, fully discharge
the battery before storing it for an extended
period (see page 92 for the details of storage).
To use a wall outlet (wall socket) for the
power source
Make the same connections as you do when
charging the battery pack. The battery pack
will not lose its charge in this case.
To check the remaining battery (Battery
Info)
Set the POWER switch to OFF (CHG),
then press DISP/BATT INFO.
After a while, the approximate recordable
time and battery information appear for
about 7 seconds. You can view the battery
information for up to 20 seconds by
pressing DISP/BATT INFO again while the
information is displayed.

BATT (battery)
release lever
Remaining battery (approx.)
Recording capacity (approx.)