Sony KDL-46XBR10 - Manual (Page 12)

12
Connecting the Unit
Cable System or VHF/UHF Antenna System
You can enjoy high-definition and standard-definition digital programming (if available in your
area) along with standard-definition analog programming.
This unit is capable of receiving unscrambled digital programming for both cable (QAM and
8VSB) and external VHF/UHF antenna (ATSC).
Cable or VHF/UHF (or VHF only)
Cable System and VHF/UHF Antenna System
Use an optional A-B RF switch (not
supplied) to switch between the cable
and over-the-air antenna programming,
as shown here.
Set the Cable/Antenna setting found
under the Settings on the XMB
™
to
Cable or Antenna for the type of input signal you choose.
HD Cable Box/HD Satellite Box
You can enjoy high-definition programming by subscribing to a high-definition service or a high-
definition satellite service. For the best possible picture, make sure you connect this equipment to
your media receiver via the HDMI or component video (with audio) input located on the rear of the
media receiver.
Shown with HDMI Connection
75-ohm coaxial cable Rear of media receiver
CABLE/
ANTENNA
• It is strongly recommended that you connect the CABLE/ANTENNA input using a 75-ohm
coaxial cable to receive optimum picture quality. A 300-ohm twin lead cable can easily be affected
by radio frequency interference, resulting in signal degradation.
B
A
Cable
Antenna
A-B RF Switch
Rear of
media
receiver
CABLE/
ANTENNA
AUDIO OUT
(VAR/FIX)
DMe x /
SERVICE
P R P B Y AUDIO R L
VIDEO IN
1
RGB
AUDIO
CABLE/
ANTENNA
COMPONENT IN
(1080p/1080i/720p/480p/480i)
(OPTICAL)
DIGITAL
AUDIO
OUT
1
3 4 2
PC IN IN LAN
REMOTE
1
AUDIO IN
AUDIO R L
AUDIO R L
Rear of media receiver
HDMI cable
HD cable box/
HD satellite box
CATV/Satellite antenna cable