Sony DVP-NC600 - Manual (Page 50)

50
• Dolby Digital 3 ch
• PCM (Stereo)
About audio signals
Audio signals recorded in a disc contain the
sound elements (channels) shown below.
Each channel is output from a separate
speaker.
• Front (L)
• Front (R)
• Center
• Rear (L)
• Rear (R)
• Rear (Monaural): This signal can be either
the Dolby Surround Sound processed
signals or the Dolby Digital sound’s
monaural rear audio signals.
• LFE (Low Frequency Effect) signal
If “DTS” is set to “OFF” in “AUDIO SETUP,” the
DTS track selection option will not appear on the
screen even if the disc contains DTS tracks (page 68).
TV Virtual Surround Sound
Settings
(TVS)
When you connect a stereo TV or 2 front
speakers, TV Virtual Surround lets you enjoy
surround sound effects by using sound
imaging to create virtual rear speakers from
the sound of the front speakers (L: left, R:
right) without using actual rear speakers.
This function is designed to work with the
LINE OUT L/R (AUDIO) 1/2 jacks. Note
that if you select one of the TVS settings
while playing a DVD, the player does not
output the Dolby Digital signals from the
DIGITAL OUT (COAXIAL or OPTICAL)
jack (when you set “DOLBY DIGITAL” in
“AUDIO SETUP” to “D-PCM”) (page 68).
1
Press SURROUND during playback.
The Control Bar is displayed.
2
Press SURROUND repeatedly to
select one of the TVS (TV Virtual
Surround) sounds.
Refer to the explanations given for each
item.
• TVS DYNAMIC
• TVS WIDE
• TVS NIGHT
• TVS STANDARD
Note
DOLBY DIGITAL 2 / 1
Front (L/R) Rear
(monaural)
PCM 96kHz 24bit
Quantized bit rate
Sampling frequency
SURROUND
TVS DYNAMIC