Read this first, Important safety instructions – Sony bloggie MHS-PM1 User Manual

Page 2

Advertising
background image

2

MHS-PM1

4-135-531-11(1)

J:\ichihashi\works\cx20300\paper\4135531111MHSPM1\020REG.fm

master:Left_Safety

Read this first

Owner’s Record

The model and serial numbers are located
on the bottom. Record the serial number in
the space provided below. Refer to these
numbers whenever you call upon your Sony
dealer regarding this product.

Model No. MHS-PM1

Serial No. ___________________________

To reduce fire or shock hazard, do
not expose the unit to rain or
moisture.

IMPORTANT
SAFETY
INSTRUCTIONS

-SAVE THESE
INSTRUCTIONS
DANGER
TO REDUCE THE RISK OF
FIRE OR ELECTRIC
SHOCK, CAREFULLY
FOLLOW THESE
INSTRUCTIONS

If the shape of the plug does not fit the power
outlet, use an attachment plug adaptor of the
proper configuration for the power outlet.

[ BATTERY PACK

If the battery pack is mishandled, the battery pack
can burst, cause a fire or even chemical burns.
Observe the following cautions.
• Do not disassemble.

• Do not crush and do not expose the battery pack

to any shock or force such as hammering,
dropping or stepping on it.

• Do not short circuit and do not allow metal

objects to come into contact with the battery
terminals.

• Do not expose to high temperature above 60°C

(140°F) such as in direct sunlight or in a car
parked in the sun.

• Do not incinerate or dispose of in fire.
• Do not handle damaged or leaking lithium ion

batteries.

• Be sure to charge the battery pack using a

genuine Sony battery charger or a device that
can charge the battery pack.

• Keep the battery pack out of the reach of small

children.

• Keep the battery pack dry.
• Replace only with the same or equivalent type

recommended by Sony.

• Dispose of used battery packs promptly as

discribed in the instructions.

Replace the battery with the specified type only.
Otherwise, fire or injury may result.

[ Battery Charger

Connect the AC Adaptor to an easily accessible
wall outlet (wall socket) close by.
Even if the CHARGE lamp is not lit, the battery
charger is not disconnected from the AC power
source (mains) as long as it is connected to the
wall outlet (wall socket). If some trouble occurs
while using the battery charger, immediately shut
off the power by disconnecting the plug from the
wall outlet (wall socket).

A moulded plug complying with BS 1363 is fitted
to this equipment for your safety and
convenience.
Should the fuse in the plug supplied need to be
replaced, a fuse of the same rating as the supplied
one and approved by ASTA or BSI to BS 1362,
(i.e., marked with an

or

mark) must be

used.
If the plug supplied with this equipment has a
detachable fuse cover, be sure to attach the fuse
cover after you change the fuse. Never use the
plug without the fuse cover. If you should lose the
fuse cover, please contact your nearest Sony
service station.

WARNING

CAUTION

Notice for customers in the
United Kingdom

Advertising