American Audio CK 800Mp3 - Manual (Page 15)

GENERAL FUNCTIONS AND CONTROLS (Cont.) FRONT & REAR PANEL
© American Audio ® - www.AmericanAudio.us - CK 800Mp3 Instruction Manual Page 15
36. RCA mASTER OUTPUTS - The RCA jacks
send a low current unbalanced output signal.
These jacks should only be used for shorter
cable runs to signal processors or looping to
another mixer. For cable runs greater than 15
feet use the Xlr Balanced jackS (33).
37. LINE 1 INPUT JACKS - do not connect
turntaBleS to theSe jackS! CD players,
Tape Decks and other line level instruments may
be connected to these jacks. The red colored
RCA jack represents the right channel input and
the white represents the left channel input. Input
volume will be controlled by channel one fader.
The channel Source Selector SWItch (17)
must be in the "Line 1" position, to monitor any
source connected to these jacks.
38. LINE 2 INPUT JACKS - do not connect
turntaBleS to theSe jackS! CD players,
Tape Decks and other line level instruments may
be connected to these jacks. The red colored
RCA jack represents the right channel input and
the white represents the left channel input. Input
volume will be controlled by channel two fader.
The channel Source Selector SWItch (17)
must be in the "Line 2" position, to monitor any
source connected to these jacks.
39. mICROPHONE - This combo jack will accept
a standard 1/4 plug or XLR 3-pin balanced male
plug. The volume output level for this micro-
phone will be controlled by its own respective
mIc knoB (29).
Note: We recommend that you
use a 500-600ohm microphone for the best
sound quality.
40. POWER BUTTON - This button is used to
turn your unit’s power on and off.
41. VOLTAGE SELECTOR - Because power
supplies vary from location to location we have
incorporated a selectable voltage switch. This
switch can select a voltage input of 115v~60Hz
or 230v~50/60Hz. Always disconnect the power
plug before changing the voltage.
Dual Voltage models only
42. POWER CONNECTOR - This connection is
used to connect your main power. Be sure that
your local power matches the unit’s required
power.
NEVER REMOVE THE GROUND PRONG
FROM THE POWER CABLE, DOING SO MAY
RESULT IN IMPROPER OPERATION.