Bits & Pieces Technology RocketChip - Manual (Page 7)

Figure 2 - A p p l e I I e M o t h e r b o a r d
STEP #4: Replacing the Apple II Expansion Boards and the cover.
Install each of your expansion/peripheral boards back into the
motherboard slot that it was removed from in Step #2. Replace the cover by
inserting the front edge of the cover into the case and pushing it forward and
then push down on the back edge of the cover to secure it
STEP #5: System Check
Turn on the system power. The monitor screen will be cleared and
within 2 seconds you will receive the system prompt and a beep. If you do not
get the beep, or if the screen has a checkboard, or if the screen is full of
“garbage characters", then RocketChip is not properly installed. IMMEDIATELY
TURN THE POWER OFF otherwise RocketChip could be damaged. Please review the
installation instructions and make sure that all of the pins are OK and that
RocketChip is installed in the correct socket and that Pin #1 is correctly
located.
6