Sony DCR-HC28 - Manual (Page 56)

56
The picture remains on the LCD screen.
• This occurs if you disconnect the DC plug from your camcorder or remove the battery pack
without turning off the power first. This is not a malfunction.
The buttons do not appear on the touch panel.
• Touch the LCD screen lightly.
• Press DISP/BATT INFO on your camcorder (p. 17).
The buttons on the touch panel do not work correctly or do not work at all.
• Adjust the screen ([CALIBRATION]) (p. 70).
The picture in the viewfinder is not clear.
• Move the viewfinder lens adjustment lever until the picture appears clearly (p. 16).
The picture in the viewfinder has disappeared.
• Close the LCD panel. The picture is not displayed in the viewfinder when the LCD panel is
open (p. 16).
Dots in lines appear on the LCD screen.
• This is not a malfunction. These dots are not recorded.
The cassette cannot be ejected from the compartment.
• Make sure the power source (battery pack or AC Adaptor) is connected correctly (p. 12).
• Remove the battery pack from the camcorder, then attach it again (p. 13).
• Attach a charged battery pack to the camcorder (p. 12).
• Moisture condensation has occurred inside the camcorder (p. 69).
The Cassette Memory indicator or title display does not appear while using a
cassette with Cassette Memory.
• This camcorder does not support Cassette Memory, so the indicator does not appear.
The remaining tape indicator is not displayed.
• Set [ REMAIN] to [ON] to always display the remaining tape indicator (p. 46).
The cassette is noisier during rewinding or fast-forwarding.
• When using the AC Adaptor, rewind/fast forward speed increases (compared with battery
operation) and therefore increases noise. This is not a malfunction.
Cassette tapes
Troubleshooting (Continued)