Sony DCR-DVD205 - Manual (Page 122)

122
The beep sounds for 5 seconds.
• The temperature of your camcorder is extremely high. Turn off your camcorder and leave it
for a while in a cool place.
• Moisture condensation has occurred with the disc. Turn off your camcorder and leave it for
about 1 hour, then turn on your camcorder again (p.139).
• Some problems have occurred in your camcorder. Remove the disc and insert it again, then
operate your camcorder again.
Unable to unfinalize.
• You cannot unfinalize a DVD-R/DVD-RW (VR mode)/DVD+RW (p.63).
• Your camcorder is in Easy Handycam operation. Cancel Easy Handycam operation (p.34) to
unfinalize a disc (p.63).
The computer does not recognize your camcorder.
• Disconnect the cable from the computer and camcorder, then connect it again firmly.
• Disconnect USB device other than the keyboard, the mouse, and the camcorder from the
computer.
• Disconnect the cable from the computer and camcorder, restart the computer, then connect
them again correctly.
When editing the images in the disc, the computer does not recognize your
camcorder.
• Install the Picture Package software (p.105).
• Confirm the USB driver is correctly installed with the following procedures.
For Windows XP
1 Click [Start], then [Control Panel].
2 Click [Performance and Maintenance], then [System].
The [System Properties] window appears.
3 Click [Hardware] tab.
4 Click [Device Manager].
The [Device Manager] window appears.
5 Make sure that [SONY DDX-C1002 USB Device] appears in [DVD/CD-ROM drives],
[Generic volume] in [Storage volumes], and [USB Mass Storage Device] in [Universal
Serial Bus controllers] respectively.
When all the devices appear, the USB driver is installed correctly. If any of these devices
are not shown, install USB driver.
1 Place the supplied CD-ROM in the disc drive on your computer.
2 Double-click [My Computer].
3 Right-click [PICTUREPACKAGE] icon (Disc drive)*, then click [Open].
*Drive names (such as (E:)) may vary depending on the computer.
Connecting to a computer (DCR-DVD305/DVD755)
Troubleshooting (continued)