Sony BDP-S560 - Manual (Page 65)

65
A
d
d
iti
o
n
a
l I
n
fo
rm
a
tio
n
The disc tray does not open and you
cannot remove the disc even after you
press Z.
, Try the following: 1 Turn the player off,
and disconnect the AC power cord.
2 Reconnect the AC power cord while
pressing down Z on the player. 3 Keep
pressing down Z on the player until the tray
opens.
4 Remove the disc. 5 When
“WAIT” appears in the front panel display,
hold down [/1 on the player for more than
10 seconds until the player turns on again.
The player does not respond to any button.
, Moisture has condensed inside the player
(page 3).
, Hold down [/1 on the player for more than
10 seconds until the indicators in the front
panel display turn off.
If the player still does not respond to any
button, disconnect then reconnect the AC
power cord.
You cannot connect your PC to the Internet
after you set the “Setting wireless LAN
(Automatic registration (WPS))” settings.
, The wireless settings of the wireless LAN
router (access point) may change
automatically if you use the Wi-Fi
Protected Setup function before adjusting
the settings of the wireless LAN router
(access point). In this case, check the
wireless settings of the wireless LAN router
(access point), and change the wireless
settings of your PC accordingly. For details,
refer to the instruction manual supplied
with the wireless LAN router (access point).
You cannot connect the player to the
wireless LAN router (access point).
, Check if the wireless LAN router (access
point) is on.
, Depending on the surrounding environment
such as the wall material, radio wave
receiving condition, or obstacles between
the player and the wireless LAN router
(access point), the communication distance
may be shortened. Move the player and the
wireless LAN router (access point) closer to
each other.
, Devices that use a 2.4 GHz frequency band
such as a microwave, Bluetooth, or digital
cordless device may interrupt the
communication. Move the player away
from such devices, or turn off such devices.
The wireless LAN router (access point) is
not displayed on “Access point scan” list.
, The wireless LAN router (access point) is
not displayed if you set the SSID to hide
with the wireless LAN router (access point).
Check and reset the SSID of the wireless
LAN router (access point) manually
(page 55).
Self-Diagnosis Function
When the self-diagnosis function is activated
to prevent the player from malfunctioning, an
error code appears in the front panel display,
or just
appears without any messages on
the entire screen.
In these cases, check the following.
When an error code appears in the front
panel display
When just appears without any
messages on the entire screen
Contact your nearest Sony dealer or local
authorized Sony service facility.
Wireless LAN
Error code Corrective action
Exxxx
SYS ERR
VUP NG Contact your nearest Sony
dealer or local authorized Sony
service facility and give the
error code.
FAN ERR • Check that the ventilation
holes on the rear of the player
are not blocked.
• Place the player in a location
with adequate ventilation to
prevent heat build-up in the
player.