ALESIS ADAT-XT - Manual (Page 19)

Chapter 2: Your First Session With The ADAT XT
16 ADAT XT Reference Manual
T RANSPORT B UTTONS
During recording and playback, the following transport buttons are used frequently.
Get familiar with them by using them while watching the TIME counter.
REWIND High speed reverse. Press with [PLAY] to initiate review mode.
FAST FWD High speed forward. Press with [PLAY] to initiate cue mode.
STOP Stops transport and disables recording.
While the transport is stopped, this button toggles between
threaded (LED is lit) and unthreaded modes (LED is flashing).
PLAY Starts playback. Initiates recording when pressed with [RECORD].
Stops recording when in record mode while continuing to play.
Press with [FAST FWD] to initiate
Cue mode.
Press with [REWIND] to initiate Review mode.
RECORD Press with [PLAY] to initiate recording.
R ECORDING
Recording takes place only on tracks that are in record-ready. When you start
recording, the [RECORD] LED lights, and the [REC] LEDs for those tracks in record-
ready will stop flashing and remain lit. If no tracks are in record-ready when recording
takes place, the [RECORD] LED will flash to indicate that pressing any of the
RECORD ENABLE buttons will initiate recording on the selected track.
To make a recording:
¿ Use the [REWIND] or [FAST FWD] button to locate to the desired tape position
Either the [REWIND] or [FAST FWD] LED will light (depending on which button
was pressed), indicating that the transport is moving in that direction. The TIME
counter will indicate the current tape location status while the transport is in
motion.
¡ When you’ve arrived at the desired tape address, press the [STOP] button.
The [STOP] LED lights.
¬ Hold [PLAY], and then press [RECORD].
Both the [PLAY] and [RECORD] LEDs will light to indicate you are recording.
÷ To go in and out of record on the individual tracks while record mode is engaged,
press any of the RECORD ENABLE buttons [1] – [8].
Record-enabled tracks will have their REC LED lit. If no tracks are record-
enabled during recording, the [RECORD] LED will flash.
ƒ To punch out without stopping, press [PLAY].
The [RECORD] LED turns off, while the [PLAY] LED remains lit.
ª To punch out and stop the transport, press [STOP]
The [RECORD] and [PLAY] LEDs turn off; the [STOP] LED lights.
Note: When recording for the first time, be sure the Auto Input function is off. When
recording over previous material (also known as punching), turn the Auto Input
function on. Use the [AUTO INPUT] button to turn Auto Input on and off. The AUTO
INPUT icon will light in the display when Auto Input is on. See page 39 for more info.