Nilfisk-ALTO BK 800 - Manual (Page 6)

7
POSSIBLE FAULTS
Fault Cause Remedy
• Set side brush correctly
• Remove pieces
• Remove pieces
• Empty container
• Set correctly
• Replace
• Empty container
• Replace damaged seals
• Reduce speed, at higher
sweeping speed swing
up the side brush arm
for large floor areas
• Clean the area behind
the roller brush
> Side brush too low
> Large pieces have got
stuck under the
sweeper
> Threads or other pieces
have fouled the roller
brush
> Refuse container full
> Side brush set too high
> Worn or damaged
sealing strip on refuse
container
> Refuse container full
> Floor seals not tight
> Sweeping speed too
high
> Fine dirt has built up
around the floor brush
‡ Difficult to push
‡ Poor refuse intake
‡ Excessive dust during
sweeping
‡ Sweeper leaves marks
behind it
GUARANTEE
For the guarantee and the
warranty our general
terms and conditions
apply. We reserve the right to make changes in
the light of technical
innovations.