4installation, 1 mounting of the housing, 2 grounding of the reader – AEG COMPACT READER ARE I2 User Manual
Page 7: 3 assemblage of the line connectors
Manual
Page 7 / 33- Revision 01
ARE I2 / RS 232 – Installation Guide
AEG
Identifikationssysteme GmbH
Söflinger Straße 100
D-89077 Ulm
Tel. ++49(0)731-933-1340/1877
Fax ++49(0)731-933-1855
e-mail: [email protected]
4
Installation
To get the specified reading performance it is necessary to do the installation carefully step by
step as it is described in the following Chapters. All the work must be done by well educated
people.
4.1 Mounting of the Housing
The reader can be mounted to any other mechanic construction. It is recommended to protect
the housing against heavy mechanical interactions.
Attention!
The side of the housing showing the antenna symbol must not be brought next to a metal
surface. This could lead to a significant change of the properties of the antenna circuit,
which in turn reduces the reading range considerably.
With the help of the plastic bars, the reader can mounted or screwed on to the most fastening
elements without open the housing of the device.
4.2 Grounding of the Reader
To get reliable reading results, the reader must be grounded. The connector is place at the side
of the housing (6.35 mm flat contact).
To avoid EMV-problems, the cable to ground ought to be very short with low impedance.
Attention! The topology of the ground wires must be done in the right way (according state of
art).
4.3 Assemblage of the Line Connectors
The connection of the power supply and data transfer cables are done by using the connectors
of the SAB Cab. The Assemblage inside of the SAB Cab is described in Chapter 4.3.1 to
4.3.7.