Sony DCR-DVD92 - Manual (Page 50)

50
DCR-DVD92/DVD103/DVD203/DVD403/DVD602/DVD653/DVD703/DVD803
2-587-622-11 (1)
Recording additional scenes after finalizing
You can record additional material on the
finalized DVD-RWs (VIDEO mode)/
DVD+RWs by following the steps below if
there is space to record on the disc.
When using the finalized DVD-RW (VR
mode) disc, you can record additional
material on the disc without any additional
steps.
• Use an AC Adaptor as power source to prevent
your camcorder from running out of power
during operation.
• Do not apply shock or vibration to your
camcorder, and do not disconnect the AC
adaptor during operation.
• A DVD menu and a Photomovie created during
finalizing are deleted.
• When you use a double-sided disc, following
procedures are required on each side.
When using a DVD-RW (VIDEO
mode) disc (Unfinalizing)
1
Connect the AC Adaptor to the
DC IN jack on your camcorder,
then connect the power cord to
the wall outlet.
2
Turn on the power by sliding the
POWER switch down.
3
Insert the finalized disc into your
camcorder.
4
Touch  [SETUP].
5
Touch DISC SET 
[UNFINALIZE].
6
Touch [YES]  [YES], then touch
when [Completed.] appears.
When using a DVD+RW
If you have created a Photomovie or a
DVD menu in finalizing (p.44), the
following steps are required.
1
Connect the AC Adaptor to the
DC IN jack on your camcorder,
then connect the power cord to
the wall outlet.
2
Slide the POWER switch down to
light up the (Movie) or (Still)
lamp.
3
Insert the finalized disc into your
camcorder.
A confirmation dialog asking if you
record additional scenes appears.
4
Touch [YES]  [YES].
[Completed.] appears, then the
screen returns to the recording screen.