Sony DCR-DVD92 - Manual (Page 5)

5
DCR-DVD92/DVD103/DVD203/DVD403/DVD602/DVD653/DVD703/DVD803
2-587-622-11 (1)
DCR-DVD92/DVD103/DVD203/DVD403/DVD602/DVD653/DVD703/DVD803
2-587-622-11 (1)
•
You can use 8cm DVD-Rs, 8cm DVD-
RWs and 8cm DVD+RWs only. Use the
discs with marks listed below.
•
For reliability durability of recording
/playback, we recommend that you use
Sony discs or discs with an
*
for VIDEO CAMERA mark for your
DVD Handycam. Using a disc other
than above may cause the unsatisfactory
recording/playback or you may not be
able to remove the disc from your DVD
Handycam.
* Depending on the place you bought, the
disc has a mark.
Notes on use
•
Hold the disc by its edge while supporting
the center hole lightly. Do not touch the
recording side (the opposite of the printed
side when using a single sided disc).
•
Before shooting, be sure to remove
dust and fingerprints from the disc with
the cleaning cloth supplied with your
camcorder.
Otherwise you may not be able to record
or play normally in some situations using
that disc.
•
When you set the disc in your camcorder,
press firmly until it clicks. When the
message [C:13:
 ] appears on the LCD
screen, open the disc cover and set the
disc again.
•
Do not attach any adhesive material such
as a sticker on the surface of a disc. If you
do so, the disc may become unbalanced,
and this may cause a malfunction of the
disc or your camcorder.
About the disc
Care and storage of the discs
•
Keep the disc clean, or the quality of the
audio and video output may deteriorate.
•
Clean the disc with the supplied cleaning
cloth.
Wipe the disc from the center out. For
dirt, clean the disc with a soft cloth
slightly moistened in water, then remove
the moisture with a soft, dry cloth. Do
not use solvents such as benzine, cleaners
intended for vinyl LPs or antistatic splay,
as they may cause a malfunction to the
disc.
•
Do not expose the disc to direct sunlight
or leave it in a humid place.
•
When you carry or store the disc, put it in
its case.
•
When you want to write letters or marks,
etc. on a single sided disc, write only on
the printed side using an oil-based marker
with a felt-tip, and do not touch the ink
until it dries. Do not heat the disc or use a
sharp-pointed tool, such as ball point pen.
Do not dry the surface by heating. You
cannot write on, or mark, on the double-
sided discs.