Replacing the cover, Upgrading and maintaining your computer, Overview – Sony PCV-R539DS User Manual

Page 476: Removing the cover

Advertising
background image

Upgrading and Maintaining Your Computer

Overview

In the future you may want to install additional boards to expand the functionality of your
computer. This section describes how to open your computer and insert add-in boards, add
memory, replace the lithium battery, and install an additional hard disk drive. For more information
on upgrading your Sony computer, see the computer Reference Manual. You can download the
Reference Manual from the Sony web site at

http://www.sony.com/pcsupport

The procedures in this section assume you are familiar with the general terminology associated with
personal computers and with the safety practices and regulatory compliance required for using and
modifying electronic equipment. Read

Notes on Use

before upgrading your Sony computer.

Always switch the power off before you open the system or connect your computer to peripheral equipment;

otherwise, damage may occur to the integrated circuits in your computer.

Electrostatic discharge (ESD) can damage disk drives, add-in cards, and other components. Do the procedures

described here only at an ESD workstation. If such a station is not available, do not work in a carpeted area and do
not handle materials that produce or hold static electricity (cellophane wrappers, for example). Ground yourself by
maintaining continuous contact with an unpainted metal portion of the chassis while performing the procedure.

Removing the Cover

If you remove the cover immediately after you shut down your computer, the components may be too hot to

touch. Wait until the internal parts of the system unit cool down before you attempt to remove the cover.

1. Press the two tabs on the right side of the rear frame.

2. Remove the frame from the unit by gently pulling it from left to right.

Add-in board configuration varies by model.

3. Remove the screws from the center top, the lower left corner, and the lower right corner of the

metal back plate.

4. Lift the three-sided outer panel by pulling up on the large tab extending from the top rear. Lift the

Page 476

Advertising