Sony DCR-DVD108BDL - Manual (Page 106)

106
Maintenance and precautions (Continued)
On handling the casing
• If the casing is soiled, clean the camcorder body
with a soft cloth lightly moistened with water,
and then wipe the casing with a dry soft cloth.
• Avoid the following to avoid damage to the
finish:
– Using chemicals such as thinner, benzine,
alcohol, chemical cloths, repellent, insecticide
and sunscreen.
– Handling the camcorder with above
substances on your hands.
– Leaving the casing in contact with rubber or
vinyl objects for a long period of time.
On the pickup lens
• Do not touch the lens inside the disc
cover. Keep the disc cover closed except
when inserting and removing the disc, to
keep dust out.
• When your camcorder does not work
because the pickup lens is dirty, clean it
with a blower (not supplied). Do not touch
the pickup lens directly during cleaning
because this may cause the camcorder to
malfunction.
About care and storage of the lens
• Wipe the surface of the lens clean with a soft
cloth in the following instances:
– When there are fingerprints on the lens
surface.
– In hot or humid locations
– When the lens is exposed to salty air such as
at the seaside.
• Store in a well-ventilated location subject to
little dirt or dust.
• To prevent mold, periodically clean the lens as
described above. It is recommended that you
operate your camcorder about once a month to
keep it in optimum state for a long time.
Cleaning inside the viewfinder
Remove any dust from inside the
viewfinder by following the steps below.
1 Pull out the viewfinder.
2 While pushing in the tab on the side with a
fine-tipped object such as a ball point pen,
pull the eyecup block in the direction of the
arrow to remove.
3 Remove dust from the eyecup block with a
camera blower, etc.
4 Press the viewfinder onto the body of the
camcorder.
5 Remove dust from the inside area where
the eyecup block was attached with a
camera blower, etc.
Pickup lens