Innovative Office Products 7000 - Manual (Page 5)

FLEXmount ™
Set-up Options Page 4
Desk Edge Clamp Mount
Drop the nylon stop nut into the impression on the inside of the metal mount column.
The rounded top of the nylon stop nut should be facing upwards.
Step 1
Position the mount cup, base plate and the large “L” bracket so that the center holes
are aligned as shown in the picture on the left.
To screw the three parts together use the 3/8-16 x 1” flat head socket cap screw and
the 7/32” allen wrench. Insert the 3/8-16 x 1” screw through the counter sunk hole in
the large “L” bracket so that it engages the nylon stop nut. Tighten with the 7/32” allen
wrench. The assembly is secure when the 3/8” screw no longer turns.
Step 2
Step 3
Align the small “L” bracket with the holes on the side of the large “L” and attach with
3/8-16 x 7/8” Flat Head Socket Cap Screw.
Step 4
Line up the center hole on the spacer with the hole in the small “L” bracket; insert the
male end of the 3” screw and begin turning it until the spacer touches the bottom of the
surface of the desk.