Advanced Global Technology QSP-660 - Manual (Page 8)

Advanced Technology Video, Inc.
QSP-660: Instructions for Basic Operation and Installation Page 8
Advanced Technology Video
QSP660 V3.200
1: Set Time/Date . . .
2: Camera Set Up . . .
3: Sequence Set Up . . .
4: Alarm Set Up . . .
5: Other Options . . .
6: Language
Camera: Select
5 is VCR + 1
6 is VCR + 2
DISPLAY: Exit Menu System
Set Time/Date
12:03:28 23 MAR 98 MON
1: Edit Hours 4: Edit Day
2: Edit Minutes 5: Edit Month
3: Edit Seconds 6: Edit Year
7: Edit Day of Week
8: Time format AM/PM/24hr
9: Other Display Options
Camera: Select
5 is VCR + 1
6 is VCR + 2
7 is VCR + 3
8 is VCR + 4
9 is QUADRANT
0 is PIP
DISPLAY: Accept and Return
S ET U P M ENUS
The QSP-660 set up is accomplished through its on-screen menus. To enter the menu system, push and hold
the DISPLAY button for approximately 3 seconds. The display will then show the top-level menu. Selection of
any menu item is done with the camera buttons. Selecting DISPLAY will exit the present menu level.
Main Menu
Selecting:
1. Enters Set Time/Date menu to program the internal
clock and select time and date display options.
2. Enters Camera Set Up menu to program camera
labels.
3. Enters Display Sequence Set Up menu to set
sequence cameras to be displayed.
4. Enters Alarm Set Up menu to enable/disable alarms
and program alarm action.
5. (Press VCR+1) Enters the Other Options menu
where you can select remote control code, program a
security code for locking out the menus and the front
panel buttons, or reset unit to factory defaults.
6. (Press VCR+2) Selects the language used for QSP-
660 menus and messages.
Set Time/Date
Time and date for the on-screen calendar and clock is set from this menu.
Selecting:
1. Edits the hour of the day. In 24-hour mode, 0 through
23 are accepted as entered.
2. Edits the minutes field. Only values 0 through 59 are
accepted.
3. Edits the seconds field. Only values 0 through 59 are
accepted.
4. Edits the day of the month. Only valid values for the
month selected will be accepted.
5. (Press VCR+1) Advances the month with each press.
6. (Press VCR+2) Edits the year.
7. (Press VCR+3) Edits the day of the week.
8. (Press VCR+4) Toggles the format between 24-hour
AM / PM.
9. (Press QUADRANT) Enters the Other Display
Options menu to turn the Time/Date display on or off,
or to change the position of the display on the screen.
The times shown in this menu come directly from the internal
clock. Actual time is constantly changing while new values are entered. All the values shown on the screen
are updated any time one of them is entered. To accurately set the clock to the desired time, edit the
SECONDS entry last. The current time and date are preserved if a new entry is not accepted or completed.