Sony DVP-F21 - Manual (Page 64)

64
Controlling Your TV, etc.
with the Supplied Remote
By adjusting the remote signal, you can
control your TV or Sony Active Speaker
System SA-F21 (not supplied) with the
supplied remote.
Notes
• Depending on the units being connected, you may
not be able to control your TV or Sony AV amplifier
(receiver) using some of the buttons below.
• If you enter a new TV code, the code previously
entered will be erased.
• When you replace the batteries of the remote, the TV
code may be reset to the default setting. Reset the
appropriate code.
Controlling TVs with the remote
1
Slide the TV/DVD switch to “TV.”
2
Hold down ?/1, and enter your TV’s
manufacturer’s code (see the table)
using C/X/x/c.
3
Release ?/1.
Manufacturer’s codes of controllable
TVs
Controlling the TV
When you set the TV/DVD switch to “TV,”
you can control your TV using the buttons
below.
TV/VIDEO
VOL
?/1 TV/DVD
WIDE MODE
C/X/x/c
By pressing You can
?/1 Turn the TV on or off
VOL (volume) +/– Adjust the volume of the
TV
TV/VIDEO Switch the TV’s input
source between the TV and
other input sources
WIDE MODE Switch to or from the wide
mode of a Sony wide TV
Manufacturer Press C/X/x/c to input code
Sony (default) XX
Fisher Xx
General Electric XC
JVC xX
Magnavox Xc
Panasonic cc
Philips Xc
Quasar cx
RCA XC
Samsung xc
Sanyo Xx
Sears cC or XC or Xx
Sharp cx
Teknika Xc
Toshiba cC
Zenith cX