Hardware setup – Asus INTEL TUSL2-C User Manual
Page 24
ASUS TUSL2-C User’s Manual
3. HARDWARE SETUP
24
System Memory
3. H/W SETUP
3.5 System Memory (DIMM)
NOTE: No hardware or BIOS setup is required after adding or removing memory.
This motherboard uses only Dual Inline Memory Modules (DIMMs). Sockets are
available for 3.3Volt (power level) unbuffered Synchronous Dynamic Random Ac-
cess Memory (SDRAM). One side (with memory chips) of the DIMM takes up one
row on the motherboard.
Memory speed setup is possible through BIOS, Section 4.4.1 Chip Configuration.
NOTE: Make sure the total installed memory does not exceeds 512MB. Otherwise,
the system may hang during startup.
3.5.1 General DIMM Notes
•
ASUS motherboards support SPD (Serial Presence Detect) DIMMs. This is the
memory of choice for best performance vs. stability.
•
BIOS shows SDRAM memory on bootup screen.
•
Single-sided DIMMs come in 16, 32, 64,128, 256MB; double-sided come in 32,
64, 128, 256, 512MB.
Install memory in any combination as follows:
DIMM Location
168-pin DIMM
Total Memory
Socket 1 (Rows 0&1)
SDRAM 8, 16, 32, 64, 128, 256, 512MB x1
Socket 2 (Rows 2&3)
SDRAM 8, 16, 32, 64, 128, 256, 512MB x1
Socket 3 (Rows 4&5)
SDRAM 8, 16, 32, 64, 128, 256, 512MB x1
Total System Memory (Max 512MB)
=