AT&T Turbo 802.11b - Manual (Page 5)

Adapter Configuration
AT&T Plug&Share ™ Wireless PCI Adapter 22 Mbps Turbo 6500B4X 5
STEP 4: Configure the PCI adapter for your wireless network
To configure the PCI adapter for communication with your wireless network, use the Configuration
Wizard. To start the Configuration Wizard, double-click on the Utility icon (four vertical bars) next to your
computer’s time display.
Wizard screen 1
SSID
Enter the SSID (Service Set
Identifier) used by your wireless
router or access point. The default
SSID is at&t. You should change this
name to any alphanumeric (numbers
and/or letters) identifier up to 32
characters long. The SSID is case
sensitive (i.e., “cat” and “Cat” are not
the same). All wireless adapters on
your network must use the same
SSID as your wireless router and/or
access point.
WEP Encryption
WEP is a form of encryption. If you
click On to enable encryption in your
wireless adapter, you must turn on
WEP in your router, and make sure
all devices use the same settings.
Click Apply to save your settings and
display Wizard screen 2 (see next page).
Double-click here to display Wizard screen 1 (see below)
Wizard • Link Info. • Configuration • Security • Site Survey • About
CAUTION: SSID and all WEP settings must be identical in all wireless network devices. WEP
Ascii/Hex Key must match the WEP settings used in your router (may be called Security Phrase,
Hex Key or other term).