Alpine CVA-1004 - Manual (Page 10)

8
-EN
Basic Operation
Adjusting Volume/Balance
(Between Left and Right)/Fader
(Between Front and Rear)
1
Press MODE (Rotary encoder) repeatedly to
choose the desired mode.
Each press changes the modes as follows:
Volume: 0~35
Balance: L15~R15
Fader: R15~F15
NAV.Level: 0~15
Subwoofer: 0~15
NOTE
• If the Rotary encoder is not turned in 5 seconds after
selecting the BALANCE, FADER, NAV. Level or
SUBWOOFER mode, the unit automatically returns to
the VOLUME mode.
∗
1 When the SUBWOOFER mode is OFF (page 34), its
level cannot be adjusted.
∗
2 When the NAV.MIX mode is OFF (page 20), its level
cannot be adjusted.
2
Turn MODE (Rotary encoder) until the desired
sound is obtained in each mode.
Audio Mute Function
Activating this function will instantly lower the
volume level by 20 dB.
1
Press MUTE/SETUP to activate the MUTE
mode. The audio level will decrease by about
20 dB.
Pressing MUTE/SETUP again will bring the
audio back to its previous level.
→ NAV ∗
1
→ SUB-W ∗
2
→ BAL → FAD → VOL
Adjusting the Monitor Viewing
Angle
Adjust the monitor's angle for better visibility.
1
Press TILT
77777 88888 to adjust the monitor's angle so
the screen will be in the best viewing position.
Each press of the buttons produces a beep and
changes the screen angle between about 40 and
105 degrees.
When you press and hold
77777 or 88888 (TILT) for at
least 2 seconds, the monitor's angle keeps
moving until you release the button.
NOTES
• If the monitor touches an obstacle while the angle is
being adjusted the unit will stop the screen
immediately.
Should this happen, remove the obstacle and press
TILT
7 8 again.
• The screen color will vary when viewed at certain
angles. Adjust the screen angle for the best viewing
position.
• If the voltage of the vehicle's battery power is low, the
screen may blink when the screen angle is changed.
This is normal and not a malfunction.
CAUTION
Keep hands (or any other object) away from the display
while it is opening or closing to avoid damage or injury.
The back of the movable display will get very warm
under normal operating conditions. This is not a
malfunction. Do not touch.
MUTE/SETUP
MODE (Rotary encoder)
TILT 77777 88888