Sony VPL-HW40ES - Manual (Page 53)

Oth
e
rs
53
3D video images
Others
Symptom Cause and Remedy
The video image does not
seem like 3D video images. c Check if the 3D glasses are turned on.
c Make sure that the battery in the 3D glasses is charged.
c Check if the input source is HDMI.
c Set “2D-3D Display Sel.” to “Auto” or “3D” (1 page 41).
c Check if the input signals are compatible 3D signals (1 page
68).
c If no 3D signal is input from the 3D equipment connected to the
projector, restarting the connected 3D equipment may solve the
problem.
c When the viewing or projector position is too far from the
screen, the 3D glasses may not be able to display the images
properly (
1 page 23).
c If you use the optional 3D Sync Transmitter, check that it is
placed within the specified range ( 1 page 16).
c The screen size is not appropriate. Set the zooming
magnification to low or watch the image from farther away from
the screen (
1 page 74).
Symptom Cause and Remedy
The fan is noisy. c Check the setting of “Cooling Setting” in the Setup menu.
( 1 page 39)
c Make sure that the room temperature is not too high.
c Check the installation conditions.
The number of fan rotation increases to maintain the product
reliability of the projector’s components in a room, where the
temperature is higher than normal. The fan noise becomes
slightly louder. The approximate normal temperature is 25°C.
The lens shift cannot be
adjusted. c The lens shift cannot be adjusted over the range of movement.
Adjust the lens shift within the range of movement ( 1 page
11).
The projector and
connected equipment turn
On/Off, play back, and
operate at the same time. c “Control for HDMI”, “Device Auto Power Off”, and “PJ Auto
Power ON” are set to “On”. Set them to “Off”.
For details, see “HDMI Setting” (
1 page 42).