Sony DVP-CX860 - Manual (Page 73)

73
Settings and Adjustments
1 2 3
4 5 6
7 8 9
0
A B C D ALL
DVD EDIT
MEGA
SORT FILE
LOAD
CD
3 Release ?/1.
Code numbers of controllable AV receivers
(amplifier)
If more than one code number is listed, try entering them
one at a time until you find the one that works with your
AV receiver (amplifier).
Manufacturer Code number
Sony 91 (default), 89
Denon 84, 85, 86
Kenwood 92, 93
Onkyo 81, 82, 83
Pioneer 99
Sansui 87
Technics 97, 98
Yamaha 94, 95, 96
Notes
• If you enter a new code number, the code number previously
entered will be erased.
• When you replace the batteries of the remote, the code number
may be reset to the default setting. Reset the appropriate code
number.
Controlling the AV receiver (amplifier)
When you set the TV/DISC EXPLORER/DVD switch to
DVD, you can change the volume of the AV receiver
(amplifier) using VOL.
Note
Depending on the AV receiver (amplifier), you may not be able to
control your AV receiver (amplifier).
VOL
Controlling the TV
When you set the TV/DISC EXPLORER/DVD switch to
TV, you can control your TV using the buttons below.
By pressing
? /1
TV/VIDEO
VOL
CH
WIDE MODE
Number buttons
and ENTER
Note
Depending on the TV, you may not be able to control your TV or
to use some of the buttons above.
Controlling AV receivers (amplifiers) with
the remote
1 Slide the TV/DISC EXPLORER/DVD switch to DVD.
2
Hold down ?/1, and enter your AV receiver’s
manufacturer’s code (see the table) using the
number buttons.
You can
Turn the TV on or off
Switch the TV’s input source between
the TV and other input sources
Adjust the volume of the TV
Select the channel of the TV
Switch the wide picture on or off
Select the channel of the TV
TV/VIDEO
ENTER
?/1
Number
buttons
Set the TV/DISC
EXPLORER/DVD
switch to TV.
VOL
CH
ENTER
?/1
Number
buttons
Set the TV/DISC
EXPLORER/DVD
switch to DVD.
WIDE MODE
Set the TV/DISC
EXPLORER/DVD
switch to DVD.
1 2 3
4 5 6
7 8 9
0
A B C D ALL
DVD EDIT
MEGA
SORT FILE
LOAD
CD
1 2 3
4 5 6
7 8 9
0
A B C D ALL
DVD EDIT
MEGA
SORT FILE
LOAD
CD