Sony DRN-XM01CK2 - Manual

I
Affixing the ferrite core to the XM antenna
Affixing the ferrite core to the AC power
adaptor (AC-E60A)
Affixing the ferrite core to the car battery cord
(DCC-E260)
DRN-XM01C/XM01R/XM01H/XM01CK/XM01HK
Sony Corporation © 2001 Printed in Japan 3-236-434-12(1)
How to affix the ferrite cores
You must affix the cores (supplied with the model you purchased) in
order to comply with Part 15 of the FCC Rules.
Wind the cord around the ferrite core once or twice, and then fasten the
catch. Make sure that each ferrite core should be attached to the
appropriate position as shown in the diagram below.
Affixing the ferrite cores to the RF modulator
POWER ANT
DC OUT AUDIO
RFC-8 RFC-8 RFC-8
RFC-8
RFC-8
Wind once or twice.
Cord
Fasten the catch.
Wind the cord
around the
RFC-8 ferrite
core twice,
then fasten
the catch.
Wind the cord
around the
RFC-8 ferrite
core twice,
then fasten
the catch.
Wind the cord around the
RFC-8 ferrite core once,
then fasten the catch.
Approx.
10 mm
(13/32
inches)
Approx.
10 mm
(13/32
inches)
Wind the black
and red cords
around the RFC-8
ferrite core twice,
then fasten the
catch.
Approx.
10 mm
(13/32
inches)
Approx. 5 mm
(7/32 inches)
Wind the cord around the
RFC-8 ferrite core once,
then fasten the catch.
Approx. 10 mm
(13/32 inches)
Rubber
Wind the cord around the
RFC-8 ferrite core twice,
then fasten the catch.
Approx. 5 mm
(7/32 inches)
Wind the cord around the
RFC-8 ferrite core twice,
then fasten the catch.
Approx. 5 mm
(7/32 inches)