Setup 6:adjust the height and tilt, Setup 6: adjust the height and tilt – Sony SDM-X53 User Manual

Page 11

Advertising
background image

10

If no picture appears on your screen

• Check that the power cord and the video signal cable are

properly connected.

• If “NO INPUT SIGNAL” appears on the screen:

– The computer is in the power saving mode. Try pressing any

key on the keyboard or moving the mouse.

– Check that the input signal setting is correct by pressing the

INPUT button (page 11).

• If “CABLE DISCONNECTED” appears on the screen:

– Check that the video signal cable is properly connected.
– Check that the input signal setting is correct by pressing the

INPUT button (page 11).

• If “OUT OF RANGE” appears on the screen, reconnect the old

monitor. Then adjust the computer’s graphics board within the
following ranges.

SDM-X53

SDM-X73/X93

For more information about on-screen messages, see “Trouble
symptoms and remedies” on page 21.

No need for specific drivers

The monitor complies with the “DDC” Plug & Play standard and
automatically detects all the monitor’s information. No specific driver
needs to be installed on the computer.
The first time you turn on your computer after connecting the monitor, the
setup Wizard may appear on the screen. In this case, follow the on-screen
instructions. The Plug & Play monitor is automatically selected so that
you can use this monitor.

The vertical frequency is set to 60 Hz.
Since flickers are unobtrusive on the monitor, you can use it as it is. You
do not need to set the vertical frequency to any particular high value.

Setup 6: Adjust the height and tilt

This monitor can be adjusted within the angles shown below.

Grasp the sides of the LCD panel, then adjust screen
angles.

To use the monitor comfortably

Adjust the viewing angle of your monitor according to the height
of your desk and chair, and so that light is not reflected from the
screen to your eyes.

Note

When adjusting the screen tilt and height, proceed slowly and carefully,
being sure not to hit the monitor against the desk.

Analog RGB

Digital RGB

Horizontal
frequency

28–61 kHz

28–49 kHz

Vertical
frequency

48–75 Hz

60 Hz

Resolution

1024

× 768 or less

Analog RGB

Digital RGB

Horizontal
frequency

28–80 kHz

28–64 kHz

Vertical
frequency

48–75 Hz

60 Hz

Resolution

1280

× 1024 or less

approx.
100 mm
(4 in)

approx.
20°

approx. 175°

approx.
175°

approx.

Advertising
This manual is related to the following products: