APC AP7003 - Manual (Page 16)

12
Drainage continued
Emptying the
tank To manually drain the tank:
1. Turn off the unit.
2. Using the handle, slowly remove the tank from the side of
the unit.
3. Pour out any condensation accumulated in the tank.
4. Wipe up any condensation that may have drained off the
evaporator coil.
5. Replace the tank in the unit.
6. Turn the power on and make sure tank is properly seated
(the unit will beep and Tank Full indicator will flash if tank
is not properly positioned).
7. Allow the fan to run for an additional three minutes after
emptying the tank to dry out the moisture in the evaporator
coil.
Continued on next page