Sony VPL-HS3 - Manual (Page 7)

Con
n
ect
ions a
n
d
P
repar
ati
o
n
s
7
GB Step 1: Installing the Projector
Do not use the projector under the following
conditions:
Tilting the unit extremely
Blocking the ventilation holes
Tip
For further details on the location of the ventilation holes (intake
or exhaust), see “Location of Controls” on page 45.
Placing the projector without the adjuster
Note
Installing the unit at altitudes
When using the projector at an altitude of 1,500 m or
higher, turn on high altitude mode in the INSTALL
SETTING menu. Failing to set this mode when using
the projector at high altitudes could have adverse
effects, such as reducing the reliability of certain
components.
The installation distance between the projector and
screen varies depending on the size of the screen.
Note
When installing the projector and screen, be sure not to tilt them.
If you tilt either or both of them, the adjustment cannot be
correctly carried out.
1
Determine the installation
position of the projector and
screen.
a: Minimum projection distance between the
screen and the center of the projector’s lens
when you place the projector on the side
(“Side Shot”), or when you place the
projector with the center of the screen and the
center of the lens aligned.
b: Maximum projection distance between the
screen and the center of the projector’s lens
when you place the projector on the side, or
when you place the projector with the center
of the screen and the center of the lens
aligned.
c: Maximum horizontal distance between the
right/left end of the screen and the center of
the projector’s lens when the projector is
placed on the side (when you use projection
distance a)
d: Maximum horizontal distance between the
right/left end of the screen and the center of
the lens when the projector is placed on the
side (when you use projection distance b)
Ventilation
holes
(exhaust)
Ventilation
holes
(intake)
Installing the Projector and
a Screen
a
e
b
c d
f 8˚
5˚
Screen
Projector