Sony HDR-TG1 User Manual
Page 64
64
100
The zebra pattern appears at a screen
brightness level of about 100 IRE or
higher.
b
Notes
• Portions of the screen where brightness is about
100 IRE or above may appear overexposed.
z
Tips
• IRE represents the unit of images brightness
amplitude.
B
ON
Always displays the remaining “Memory
Stick PRO Duo” indicator.
AUTO
Displays the remaining recording time of
movies for about 8 seconds in situations
such as those described below.
– When your camcorder recognizes the
remaining “Memory Stick PRO Duo”
capacity while the
(Movie) lamp
lights up
– When you press DISP/BATT INFO to
switch the indicator from off to on while
the
(Movie) lamp lights up
– When you select the movie recording
mode on the HOME MENU.
b
Notes
• When the remaining recordable time for movies
is less than 5 minutes, the indicator stays on the
screen.
When you set to [ON] (the default setting),
you can display the recording date and time
while playing back the images recorded on
your camcorder, on devices compatible
with the subtitle display function. Refer
also to the instruction manual of the display
device.
b
Notes
• The images recorded with HD (high definition)
image quality can be played back only on
AVCHD format compatible devices.
• [SUB-T DATE] cannot be set for SD (standard
definition) image quality.
You can select the flash setting when you
record still images with the built-in flash.
B
AUTO
Automatically flashes when there is
insufficient ambient light.
ON ( )
Always uses the flash regardless of the
surrounding brightness.
OFF (
)
Records without flash.
b
Notes
• The recommended distance to the subject when
using the built-in flash is approximately 0.3 to
1.5 m (1 to 5 feet).
• Remove any dust from the surface of the flash
before using it. Flash effect may be impaired if
heat discoloration or dust obscures the lamp.
• The
/CHG (charge) lamp flickers while
charging the flash, and remains lit when the
battery charge is complete.
• If you use the flash in bright places such as
when shooting a backlit subject, the flash may
not be effective.
You can set this function when you use the
built-in flash.
HIGH(
)
Makes the flash level higher.
B
NORMAL( )
LOW(
)
Makes the flash level lower.
REMAINING SET
SUB-T DATE
(Subtitle date)
FLASH MODE
FLASH LEVEL