AT&T DEFINITY 8102 - Manual (Page 3)

To answer a call waiting tone, putting your present
call on hold
1 Press [ FLASH ] [recall dial tone]
2 Dial Hold code
● You are connected to waiting call
To return to held call
1 Complete present call and hang up
● Held call sends 3-burst priority ring
2 Lift handset
● You are connected to held call
CONFERENCE [ ✔ ]
To add a third party to a call
1
2
3
Press [ FLASH ] [recall dial tone]
● Present call is put on hold
Dial number of third party
Note: You can privately discuss the call with the
third party at this time; if no answer or busy, press
[ FLASH ] twice to return to original party.
Press [ FLASH ]
2
● All parties are now connected
To drop a third party
1 Press [ FLASH ]
● You remain connected to original party
DROP (for 8102 and 8110 Users) [ ]
To disconnect from a normal call, or to drop the
last party added to a conference call
1 Press the button you have programmed
as [ DROP ]
HOLD (with Second Dial Tone) [ ✔ ]
Note: The following feature allows you to place or
answer another call or activate another feature while
you have a call on hold. If you want merely to put a
call on hold while you are busy with another task (and
5
do not need to answer or place another call), press
[ HOLD ] on your telephone. When you want to return
to the held call, press [ HOLD ] again. See “Hold” in the
section titled Phone Features.
Version Note: If you are using System 75, Version 1,
use the following directions:
To put a call on hold
1 Press [ FLASH ] [recall dial tone]
Note: Do not hang up or call will be dropped.
To return to held call
1 Press [ FLASH ] twice
To put call 1 on hold and place call 2
1 Press [ FLASH ] [recall dial tone]
● Call 1 is put on hold
Dial call 2 (or another feature)
To complete call 2 and return to call 1
1 Press [ FLASH ] [recall dial tone]
2 Press [ FLASH ] twice
● Call 1 is reconnected
To complete call 2 and return to call 1
1 After party on call 2 hangs up, press [ FLASH ] twice
● Call 1 is reconnected
Version Note: If you are using System 75, Version 2,
Version 3, or DEFINITY Generic 1, use the following
directions:
To put a call on hold
1 Press [ FLASH ] [recall dial tone]
2 Dial Hold code [dial tone]
Note: If you hang up, held call sends a 3-burst
priority ring.
To return to held call
Hang up, receive 3-burst priority ring, and lift handset
To put call 1 on hold and place call 2
1
2
Press [ FLASH ] [recall dial tone]
Dial Hold code [dial tone]
● Call 1 is put on hold
6