Sony VPL-HS2 - Manual (Page 32)

Ot
her
s
GB
32 Replacing the Air Filter
6 While pushing the projector cover toward
you by holding both sides of the cover on
the lens side, close the cover until it clicks.
7 Connect the power cord and set the
projector to standby mode.
8 Press the following buttons on the remote
control in the following order for less than
five seconds each: RESET,
< , , , ENTER.
Notes
• Do not put your hands into the lamp replacement spot, and do
not allow any liquid or object to fall into it to avoid electrical
shock or fire.
• Be sure to use the LMP-H150 Projector Lamp for replacement.
If you use lamps other than LMP-H150, a malfunction may
occur.
• Be sure to turn off the projector and unplug the power cord
before replacing the lamp.
Disposal of used projector lamp
As the materials used in this lamp are similar to those
of a fluorescent lamp, you should dispose of a used
projector lamp in the same way as a fluorescent lamp.
Replacing the Air Filter
The air filter should be replaced periodically. When
“Please replace the filter.” appears on the screen,
replace the air filter immediately.
Notes
• Replacing the air filter is very important to maintain the high
efficiency of the projector and to prevent a malfunction. When
the replacement message appears on the screen, replace the air
filter without delay.
• When removing the air filter from the projector, be careful that
no dust or object gets into the inside of the projector.
• Before replacing the air filter, turn off the projector and unplug
the power cord.
1 Hold down the adjuster lock lever, slide it
to the right, raise the rear of the projector,
then return the adjuster lock lever. While
keeping the screw on the bottom of the
projector turned inward with a coin or a
slotted screwdriver, open the projector
cover with your hand.
Note
Be sure that the projector is stable.
2 Push the filter lock knob to remove the
filter cover.
3 Remove the air filter from the filter holder
by holding the tab on the air filter.
1
2
Air filter
Filter holder