Alamo RHINO 7214 MSL - Manual (Page 35)

F-3778-12-04 Maintenance Section 5-2
GREASE
POINTS
© 2004 Alamo Group Inc.
MAINTENANCE
MAINTENANCE
Regular maintenance of your loader and hydraulic system
will ensure maximum loader efficiency and long life.
WARNING: NEVER perform maintenance
beneath a raised loader unless loader is
properly supported to prevent accidental
lowering.
DAILY MAINTENANCE
•
Check fluid level of tractor hydraulic system
before starting each day's operation. If
necessary, add hydraulic oil as recommended
in your tractor operator's manual.
•
Every four hours of operation, lubricate all
twenty-two grease fittings. One grease fitting on
the end of each pin, accessible from outside the
loader.
•
Repair hydraulic oil leaks promptly to avoid loss
of oil and serious personal injury from escaping
oil.
•
Replace hoses immediately if they are damaged
by a cut or scrape, extruded at the fittings, or
leaking.
•
After every ten hours of operation, check all
hardware and tighten where required.
WARNING: Escaping hydraulic fluid under
pressure can penetrate skin, causing serious
personal injury.
•
DO NOT use your hand to check for leaks. Use
a piece of wood or cardboard and wear eye
protection to search for leaks.
•
Stop engine and relieve pressure before
connecting or disconnecting lines.
•
Tighten all connections before starting engine or
pressurizing lines.
If any fluid is injected into skin, obtain medical attention
immediately or gangrene may result.
Grease Fitting Locations