AT&T XANBOO XG1000 - Manual (Page 3)

4 3
4. Plug the small end of the AC Power Supply into your IPC-1000 IP Camera
AC Adapter port and the other end into an AC electrical outlet.
Example of completed configurations can be found below.
2
ROUTER
(NOT INCLUDED)
INTERNET
XG1OOO CONTROLLER DSL/CABLE MODEM
(NOT INCLUDED)
1 3 4
LAN LAN WAN
COMPLETED CONFIGURATION
2
ROUTER
(NOT INCLUDED)
VIDEO TRANSMITTED OVER
POWER LINES VIA PLC ETHERNET ADAPTERS
INTERNET
XG1OOO
CONTROLLER
PLC
ETHERNET
ADAPTER
PLC
ETHERNET
ADAPTER
DSL/CABLE MODEM
(NOT INCLUDED)
IPC-1000
IP CAMERA
1 3 4
LAN LAN WAN
COMPLETED CONFIGURATION USING OPTIONAL PLC ETHERNET ADAPTERS (SOLD SEPARATELY)
IPC-1000 IP CAMERA
2
ROUTER
1 3 4
LAN WAN
ROUTER
1 3 4
LAN WAN
2
FOLLOW THE STEPS BELOW SET UP YOUR ENHANNCED REMOTE MONITORING STARTER KIT:
1. Take the XG1000 Controller AC Power Supply from your Controller box.
Plug the small end into the port marked Power on your XG1000 Controller
and plug the other end into an AC electrical outlet.
2. Connect supplied Ethernet Cable to the LAN Ethernet port of the XG1000 Controller
and connect the other end to a free Ethernet port on your router.
3. Connect one end of Ethernet Cable to the port on the bottom of the HomePlug
Turbo PLC Ethernet Adapter. Connect the other end to a second free port on your router.
NOTE: You can connect a network hub or switch to any available Ethernet port on your router,
if you need additional ports.
Plug the HomePlug Turbo PLC Ethernet Adapter into an AC electrical outlet.
For best results plug the HomePlug Turbo PLC Ethernet Adapter modules into a free AC wall outlet
directly or, if not possible, into an AC power strip that has no other AC Power Supply plugged into it.
The length of the power strip cord, or separate extension cord, should be no more than 5 feet and
it should not be coiled.
Once plugged into the AC electrical outlet, the LED’s light up on the front of the HomePlug Turbo
PLC Ethernet Adapter should light up. If the LED’s do not light up on the front of the HomePlug
Turbo PLC Ethernet Adapter, please confirm that there is AC power coming to the outlet.