Sony HDR-CX300 - Manual (Page 116)

116
US
 SCAN/SLOW buttons (29)

 /  (Previous/Next) buttons (29)
 PLAY button
 STOP button
 DISPLAY button (21)
 Transmitter
 START/STOP button (20)
 Power zoom buttons
 PAUSE button
 VISUAL INDEX button (29)
Displays a VISUAL INDEX screen during
playback.

 /  /  /  /ENTER buttons
When you press any of these buttons, the
orange frame appears on the LCD screen.
Select a desired button or an item with
 /  /  /  , then press ENTER to enter.
Notes
Remove the insulation sheet before using the
Wireless Remote Commander.
Point the Wireless Remote Commander
towards the remote sensor to operate your
camcorder (p. 114).
When no commands have been sent from the
Wireless Remote Commander within a certain
period, the orange frame disappears. When
you press any of  /  /  /  , or ENTER again,
the frame appears at the position where it was
displayed last.
You cannot select some buttons on the LCD
screen using  /  /  /  .





To change the battery of the Wireless
Remote Commander
 While pressing on the tab, inset your fingernail
into the slit to pull out the battery case.
 Place a new battery with the + side facing up.
 Insert the battery case back into the Wireless
Remote Commander until it clicks.
WARNING
Battery may explode if mistreated. Do not
recharge, disassemble or dispose of in fire.
When the lithium battery becomes weak, the
operating distance of the Wireless Remote
Commander may shorten, or the Wireless
Remote Commander may not function
properly. In this case, replace the battery with
a Sony CR2025 lithium battery. Use of another
battery may present a risk of fire or explosion.

Insulation sheet
Tab