Antec TRUEPOWER QUATTRO TPQ-1200 - Manual (Page 6)

I
NSTALLATION
:
1.
Install the TPQ-1200 PSU into your case with the four screws provided.
2. Connect the 24-pin main power connector to your motherboard.
3. Connect the 8-pin or 4-pin ATX12V connector for the CPU to the appropriate connector on your
motherboard. If your motherboard has an 8-pin socket with a cover on some of the openings, we
recommend that you remove the cover and use the 8-pin connector.
Note: Please also refer to your motherboard user’s manual for any special instructions.
4. Connect the cables from the cable pack to the socket on the power supply as needed. If you are going to
plug the additional PCI-E cable into the PSU, it should go into the red socket. If the red socket is not being
used for PCI-E, then it can be used for another cable from the pack that accompanies the PSU.