ASA Electronics DVDVCP01 - Manual (Page 37)

35
THE
OT
HERS
BEFORE DOUBTING ABOUT TROUBLES (VCP)
There is no power
to the VCP.
Noise bars on
screen.
Operation key
does not work.
Cassette is
ejected upon
inserting.
Audio output does
not change to Hi-
Fi mode.
No back-lighting
at POWER button.
Power indicated
with back-lighting
but unit will not
operate.
¥ The power cord is not
connected.
¥ The polarity of power cord
is not correct.
¥ Tracking is not adjusted.
¥ If the cassette or the VCP
is not in normal condition,
every LED indicator lights
and the VCP is inoperative.
¥ Safety device works to
protect the cassette when
it is inserted incorrectly.
¥ The cassette was recorded
on a in mono VCR.
¥ The first autotracking
attempt is still executing
now.
¥ No 12V DC.
¥ Dew feature activated
(See ownerÕs manual for
dew mode explanation).
¥ No tape in unit.
¥ Low voltage.
¥ Check the power cord.
¥ Change the polarity of
power cord.
¥ Adjust for a clear picture
by pressing the PLAY
button.
¥ Turn the power off and on
by pressing the POWER
button.
¥ Unplug and re-plug the
power cord.
¥ Pull the cassette out
(unloading) and insert it
firmly into the cassette
compartment.
¥ The cassette can not be
played back in Hi-Fi mode.
¥ Wait for a second.
¥ Check circuit fuse at
source of power (see
vehicle/converter manual).
¥ Check in-line fuse of power
cord (in lighter plug).
¥ Power cord unplugged from
12V outlet or at rear of
unit.
¥ Retain power to player and
allow unit time to get rid
of moisture. (After 30
minutes if dew indicator is
still on, completely switch
off unit power and re-apply
after 1 minute. This can
reset dew indicator if
moisture is eliminated.)
¥ Insert the tape.
¥ Start the vehicle, if not
running.
SYMPTOMS CAUSE POSSIBLE SOLUTIONS