Antec NSK 4482B - Manual (Page 9)

7
Specifications:
Size: 120 x 120 x 25.4mm
Rated Voltage: DC 12V
Operating Voltage: 10.2V ~13.8V
Speed
(RPM)
Input
Current
Air Flow Static Pressure Noise
Input
Power
High
2000
0.24A
(max.)
2.24 m³ / min
(79 CFM)
2.54mm-H
2
O
(0.10inch-H
2
O)
30 dBA 2.9 W
Medium
1600
0.2A
1.59 m³ / min
(56 CFM)
1.53mm-H
2
O
(0.06inch-H
2
O)
28 dBA 2.4 W
Low
1200
0.13A
1.1 m³ / min
(39 CFM)
0.92mm-H
2
O
(0.04inch-H
2
O)
25 dBA 1.6 W
4.2 Front 80mm Intake Fan
An optional 80mm fan can be installed to pull air in at the bottom front of the case. A
mounting bracket is provided for this purpose.
1. Squeeze the upper right and left sides of the fan cage together to release the tabs. Once
loose, you should be able to pull the cage back and out of the case.
2. Drop the fan into the cage and push it in until it clips in. No screws are needed. The
front fan should be installed so that air is blowing into the case.
3. Reattach the cage/fan assembly to the case, making sure to not pinch the wires of the
fan. There are slots near each corner to put the wires through (any corner will work,
find the one that’s best for you).
4. If you’re using a 4-pin fan, connect a 4-pin large white connector from the power
supply. If you’re using a 3-pin fan, connect the 3-pin connector to a motherboard fan
header.
4.3 Thermally Advantaged Chassis (TAC 2.0) Air Guide
This chassis uses a thermal air guide that conforms to the Intel Thermally Advantaged
Chassis design guide. This guide is designed to provide ventilation directly to the CPU and
graphics card through the integrated air duct.