Panasonic Split System Air Conditioner - Manual (Page 7)

7
Adjusting the Airflow Direction (continued)
U1 type, Y1 type, L1 type and D1 type air conditioners are equipped with auto flaps.
You can set the airflow direction to a specific angle or to the sweep mode using the remote
control unit.
Do not move the flap with your hands.
4-way (U1 type), (Y1 type) • The air outlet flap can be easily removed and washed with water.
• Be sure to always stop operation before removing the flap.
• After washing with water, allow it to dry, and then remount it with the arrow facing outward.
„ Ceiling mounted type (T1)
Vertical directions (automatic)
This air conditioner is equipped with an auto flap. You can set the airflow direction to a specific
angle or to the sweep mode using the remote control unit. (Refer to the description of the
remote control unit.)
Do not move the flap with your hands.
Horizontal directions (manual)
The horizontal airflow direction can be adjusted manually by moving the vertical vanes to the
left or right.
„ Wall mounted type (K1)
Vertical directions (automatic)
Confirm that the remote control unit has been turned on. Press the FLAP button to start the flap
moving up and down. If you want to stop the flap movement and to direct the air in the desired
direction, press the FLAP button again. In the cool mode, do not direct the flap down and move
out of the cooling zone “A”, otherwise, condensation may drip on to the floor. Zone ‘‘A’’ is the
recommended flap position for cooling.
When operating continuously in the fixed airflow direction setting for about an hour, the airflow
direction is automatically controlled and the flap position is changed. The airflow direction may
be different from the display on the remote controller.
Do not move the flap with your hands.
Horizontal directions (manual)
The horizontal airflow direction can be adjusted manually by moving the vertical vanes to the
left or right.
„ Concealed duct type (F1, M1, E1)
This air conditioner is not equipped with air outlet parts. These must be obtained locally. Please
refer to the manual of the locally adopted air outlet parts.
Indoor unit
Zone ‘‘B’’ for
heating
Zone
‘‘A’’ for
cooling
OI-070-7-EN
01_85464609070013_EN.fm Page 7 Thursday, February 3, 2011 3:19 PM