AT&T 1856 Speakerphone - Manual (Page 10)

Getting started
Installation options
3. Connect the telephone line cord and
power adapter to the jacks on the back
of the telephone base. Bundle the tel-
ephone cord, and secure it with a twist
tie before placing it inside the bracket.
4. Plug the power adapter into an electrical
outlet not controlled by a wall switch. Plug
the telephone line cord into a telephone
wall jack. To mount the telephone on the
wall, position the mounting holes and
over the telephone outlet mounting studs.
Press and slide the bracket down firmly so
the telephone is held securely on the tel-
ephone outlet mounting studs.
Tabletop installation
To return the bracket from the wall mounting to tabletop position, follow the
directions below.
1. Remove the telephone base from the
wall. Unplug the cords from the wall jacks.
Remove the bracket from the telephone
base.
2. Rotate the bracket to tabletop
positon, insert the bracket tabs
into slots and on the tel-
ephone base, then press the
other bracket tabs into slots
and .
3. Route cords through slots. Plug the other
end of the telephone line cord into a tel-
ephone wall jack. Plug the large end of
the power adapter into an electrical out-
let not controlled by a wall switch.
7