Removing the built-in rechargeable battery – Panasonic ES8249 User Manual
Page 12
GB
12
English
Removing the built-in rechargeable battery
Remove the built-in rechargeable battery before disposing of
the shaver. Please make sure that the battery is disposed of at
an officially designated location if there is one. Do not
dismantle or replace the battery so that you can use the
shaver again. This could cause fire or an electric shock.
Replace it at an authorized service center.
Disconnect the power cord from the shaver when removing
the battery.
Perform steps
1
to
7
and lift the battery, and then remove it.
For environmental protection and recycling of materials
This shaver contains a Lithium-ion battery.
Please make sure that the battery is disposed of at an
officially assigned location, if there is one in your country.
•
•
2. Gently wipe off any beard trimmings
attached to the inside of the cleaning
tray with a cloth or tissue paper
dampened with water.
Clean the corners and uneven parts
of the cleaning tray with a cotton
swab dampened with water.
•
Warning - Do not wash or apply water to the adaptor or
self-cleaning recharger. Failure to observe this may cause
electric shock or result in short circuits.
Do not pull hard on the rubber blade protector at the
bottom of the cleaning tray. The rubber may come off if you
pull hard on it. It is only necessary to pull it up slightly.
•
•
When the water does not drain from the
cleaning tray
Beard trimmings may clog the drain at
the bottom of the cleaning tray.
In this case, you cannot clean or dry the
shaver.
Push the beard trimmings down through
the drain with a tooth pick etc.